DPF Faults. Warning Lights. Limp Mode.
If you run a Transit Custom — especially one used for short trips or site runs — you know the drill: DPF light on, regeneration failed, power cut.

That’s exactly what happened to Dan, a self-employed electrician from Leicester.

“It dropped into limp mode two days before a job in Manchester,” Dan told us.
“The garage said it needed a new filter and sensors. £1,200 all-in. I nearly cancelled the week.”

Instead, he called us.

Vehicle: 2020 Ford Transit Custom 2.0 EcoBlue

Dealer advice: Replace DPF, temperature sensor, labour and forced regen – approx. £1,200.

The Fix: Mobile DPF Delete with ECU Reprogramming

We visited Dan at his home the same evening. After scanning the vehicle and confirming all other systems were healthy, we offered a full DPF delete solution — done through the ECU only.

Time on site: 90 minutes
Tools used: Autotuner, full pre/post diagnostics

The Result

Within two hours, Dan’s van was back to full power — no faults, no lights, no limp. All error codes were cleared and the SCR system was fully stable.

He didn’t lose his job. And he didn’t pay £1,200.

“You saved my week. It’s been fault-free since and honestly pulls better than before. I won’t use anyone else now.”

Why It Matters for Vans Like This

DPF systems are one of the biggest weak points on modern diesels — especially on vans doing low-speed urban mileage.

When regeneration fails:

A delete (for off-road or export use only) can permanently stop these issues when the filter is beyond saving or already removed.

Is a DPF Delete Right for You?

We’ll confirm compatibility before starting and run full diagnostics to make sure your engine’s ready for the delete.

Areas Covered

We carry out mobile DPF deletes across:

We come to you — home, yard, or site.

Book Your DPF Solution

Ready to stop the warnings, save money, and get back on the road?

Request a Callback
Call 07849 475153

Leave a Reply

Your email address will not be published. Required fields are marked *